The dust extraction arm providers are the advantages of separate chamber blowback and pulse blowout, which overcome the disadvantages of insufficient kinetic energy strength in separate chamber blowback and simultaneous filtration and dust removal, thus increasing the adaptability of the bag dust collector and increasing the dust collection rate. dust extraction arm providers are widely used in dust collection systems such as crushing, packaging, warehouse roof, clinker coolers and various grinding machines in cement plants, as well as in metallurgy, chemical, mechanical and civil boilers.

The operation of dust extraction arm providers should be noted as follows:

1. When the dust extraction arm providers are working normally, the ash removal device should not stop working, otherwise, the dust in the ash hopper will soon fill up and overflow into the bag room, forcing the dust collector to stop working. It is found that smoke and ash from the exhaust port indicates that the filter bag has broken and leaked. During maintenance, stop the air in each room and open the top cover. If ash is found at the mouth of the bag, it indicates that the filter bag has been damaged and should be replaced or repaired.

Second, if a timing cleaning controller is used, the cleaning period should be regularly determined whether it is accurate, otherwise it should be adjusted. The use of fixed-resistance pulse controller should regularly check the working condition of the pressure switch, whether the pressure port is blocked, and clean up.

The management personnel of dust extraction arm providers should be familiar with the principle, performance and use conditions of the dust collector, and master the adjustment and maintenance methods. Master the performance and structure of the dust collector, find problems and deal with them in time, and the dust removal system runs normally. The personnel on duty shall record the operation of the shift and relevant data.

Iv. Mechanical moving parts such as ash conveyors on dust extraction arm providers shall be filled with oil and changed according to regulations, and abnormal phenomena shall be promptly eliminated. Oil the rotating part regularly.

5. The oil-water separator in the gas storage tank and gas source triplet on the dust extraction arm providers should be discharged once per shift, while the oil-water separator should be cleaned every 3 to 6 months, and the oil mist should be checked frequently for oil storage and refueled in time.

6. If the electromagnetic pulse valve fails, it should be eliminated in time, if there are impurities and moisture inside, it should be cleaned, and if the diaphragm is damaged, it should be replaced in time.

dust extraction arm providers https://www.kaisenfilter.com/Suspended-Suction-Arm